CCTV en Amaro Electronics Camaras IP,VS-IP06,H.264 D1 Sony CCD Camaras IP WIFI , SD Card and RF function

Especificaciones
Dibujo
Otros Productos

Características:

·	Support IE, DDNS and client software to realize the real-time surveillance and play-back
·	Support internet listening, internet broadcasting, two-way audio function, built-in microphone and speaker
·	Support local and internet storage, built-in Micro SD port, integrated with many internet storage protocols, support network hard disk function
·	Integrated wireless alarm gateway function, support many kinds of remote controllers and wireless detectors
·	Variety of internet protocols, Support IPv4/IPv6, HTTP, TCP, ICMP, RTP, UDP, IGMP, RTSP, SMTP, FTP, DHCP, DNS, DDNS, UPNP
·	Support local and internet alarm, mobile alarm
·	Support video motion detective, privacy protection mode
·	Support SDK integrated development
·	Support alarm linkage
·		Support IE, DDNS and client software to realize the real-time surveillance and play-back
·		Support internet listening, internet broadcasting, two-way audio function, built-in microphone and speaker

Model No

VS-IP06BSNH-1

VS-IP06CSNH-1

Image Sensor

1/3 SONY Super HAD CCD

Horizontal Resolution

520 TVL

Function

SD & WIFI Series

WIFI & SD & RF Series

Infrared Light

Infrared LEDs, effective range up to 10 m-20 m

Video Compression

H.264 Baseline Profile@Level 2.2

Video Resoulution

CCD PAL; 704 x 576 (D1), NTSC; 704 x 480 (D1)
CMOS VGA; 640 x 480, QVGA; 320 x 240

Video Parameters

Brightness, Hue, Contrast, Saturation, Image quality.

Video Frame Rate

CCD; PAL; 1-25 fps; NTSC; 1-30 fps; CMOS; 1-25 fps

Video Bitrate

16 Kbps-4 Mbps

Audio Input

1 channal Mic or linear input (configured by software)

Audio Compression

G.726

Audio Output

1 channel linear output

Supported Protocols

TCP, UDP, IP, HTTP, FTP, SMTP, DHCP, DNS, ARP, ICMP, POP3, NTP, IPsec, UPNP, RTP, RTSP

System Interface

10 Base-T/100 Base-TX Ethernet Port

1 RS 485 port

WiFi port (802.11b/g)

SD Card port

Alarm Input

1 channel on/off input, supports NO (normally open)or NC (normally close)

Alarm Output

1 channel relay output, 120 VAC 1 A/24 VDC 1 A

Power Supply

DC 12V, 1A